Apply liquid gasket thoroughly as shown. Attach the sealant tube to the tube presser. After checking, measure the compression pressure again. Remove the front exhaust tube using power tools. Do not apply oil to the back surface, but thoroughly clean the back. Remove the valve spring retainer, valve spring and valve spring seat.
Rotate the crankshaft pulley in normal direction clockwise when viewed from engine front to check for parts interference. Loosely install the front timing chain case bolts. Dismount the power steering pump with piping connected and position it aside with wire. Special care should be taken when handling any inflam- mable or poisonous materials, such as gasoline, refrigerant gas, etc. Check piston ring side clearance. At each of several locations on bottom surface of cylinder head, measure distortion in six directions.
Install the valve collet using Tools. At this time, check that the both intake and exhaust cam lobes of No. Insert clip into clip mounting groove on fuel injector. If the levels are lower than required quantity, fill to the specified level. Method of Using Plastigage Standard : 53.
Put the camshaft on a V-block supporting the No. These operations should be done on a level surface. At this time, make sure both intake and exhaust cam lobes of No. Install the main bearing caps and bearing beam to the cylinder block. Remove rear oil seal using suitable tool. Install new gaskets on the cylinder heads.
Loosen side bolts M10 starting from 30 to 21 to remove. Before removing the drive plate, put a match mark A on the crankshaft and drive plate for alignment during installation. Remove the timing chain tension guide and timing chain slack guide. Apply new engine oil to threads and seat surfaces of the bolts. Remove the front and rear engine mount vacuum lines Posititon a suitable support table under suspension member and engine assembly.
These numbers are punched in either Arabic or Roman numerals. Method of Using Plastigage Standard : 53. Inspect new replacement parts in the same way, and replace if necessary. Be careful not to damage sensor edges or signal plate teeth. Install pilot converter to the crankshaft using suitable tool.
Hold the sides of the connector, push in tabs and pull out the tube. Engine coolant temperature sensor 3. Assemble the components in their original positions. Standard Limit : 166 - 188 N 16. When the value of d1- d2 exceeds the limit a large difference in dimensions , replace the bolt with a new one. Static electricity may damage internal electronic components. Leave the car parked out- side overnight.
Remove the power steering fluid reservoir tank bolts and position the power steering fluid reservoir tank aside. Remove the valve oil seal using Tool. Remove the radiator assembly and hoses. Measure the main bearing inside diameter with the bearing cap bolts tightened to the specified torque. Remove the engine mounting insulator and bracket using power tool, if necessary.
Install the rear oil seal retainer. Install fuel tube and fuel injector assembly to intake manifold. Remove the main bearings and thrust bearings from the cylinder block and main bearing caps. Remove piston from connecting rod as follows. If necessary, remove the electric throttle control actuator bolts in the order as shown and remove the electric throttle control actuator. Remove fuel injector from fuel tube. Determine the grade by comparing the measurement with the values of each selection table.
Carefully check engine oil or engine coolant passages for any restriction and blockage. If the O-ring was stretched while it is attached, do not insert it into the fuel tube immediately. Remove the oil strainer from the oil pan upper. Install the chain guide between the camshaft sprockets. Remove the coolant overflow reservoir tank.